25 11 300 Replacing shift cable assembly

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release clips on stop/holder (1).

Detach selector lever cables (2) from ball joint.

Fig 1: Clips On Stop/Holder And Selector Lever Cables

Courtesy of BMW OF NORTH AMERICA, INC.

Remove heat shield (1).

Fig 2: Heat Shield

Courtesy of BMW OF NORTH AMERICA, INC.

Detach selector lever cables (1) from floor plate.

Fig 3: Selector Lever Cables

Courtesy of BMW OF NORTH AMERICA, INC.