35 40 001 Removing and installing or replacing accelerator pedal module

WARNING: This page is about a different variant/trim than selected.

When replacing control unit:

Take off cover (1).

Fig 1: Identifying Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release socket head cap screw (1).

Installation:

Tightening torque 35 40 1AZ .

Feed out accelerator pedal module (2) towards top.

Fig 2: Removing Accelerator Pedal Module

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove accelerator pedal module.

Fig 3: Identifying Accelerator Pedal Module Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.