51 12 070 Replacing center spoiler on rear bumper panel

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release catches (1) and remove spoiler (2).

Installation:

Catches (1) on spoiler and bumper trim must not be damaged.

Fig 1: Identifying Catches And Spoiler

Courtesy of BMW OF NORTH AMERICA, INC.

Version with PDC:

Modify all ultrasonic sensors.

Expand latch mechanisms (1) and remove ultrasonic sensor (2) in direction of arrow.

Fig 2: Identifying Catches And Ultrasonic Transducer

Courtesy of BMW OF NORTH AMERICA, INC.