4.1 Moist bonding
WARNING: This page is about a different variant/trim than selected.
- Thoroughly moisten the background surface to be bonded with low-surface- tension water.
- Pull off the backing film, position the film on the background surface and slide into position.
NOTE:
In the case of small-size film, the backing film can be pulled off completely and the adhesive side of the film can be moistened with low-surface-tension water.
- Press film down with plastic squeegee in overlapping strokes from inside outwards.
- Remove remaining water with a clean cloth.
- If necessary, carefully and slowly pull off protective film flat.
- Check film for bubbles and folds. If necessary, remove bubbles or folds with plastic squeegee or pierce with a needle and force out air or water.