Adjusting retraction depth

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Tape off door in working area of special tool 51 3 240.

Feed in special tool 51 3 240 between supports (1) and place on nut (2) in between.

Slacken nut (2) with special tool 51 3 240 until door window can be moved.

Fig 1: Adjusting Retraction Depth Using Special Tool (51 3 240)

Courtesy of BMW OF NORTH AMERICA, INC.

Attach special tool 51 3 010 and adjust door window.

Check adjustment. If necessary, repeat procedure.

Tightening torque 51 32 1AZ .

Initialize power window.