51 11 050 Removing and installing/replacing carrier for front bumper trim
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove FRONT BUMPER PANEL .
To perform this task, special tool 00 2 271 from special tool set 00 2 270 is needed.
NOTE:
The operation is described on the right side; proceed in the same way for the left side.
The position of the front panel is not altered by special tool 00 2 271. Therefore no adjustment work is required.
Remove foam insert from carrier.
Insert special tool 00 2 271 and screw down.
If necessary, release cable holder (1).
Release screws (2 and 4).
Release nuts (3) and remove carrier.
Installation note:
Make sure foam insert is correctly positioned on carrier.
Tightening torque 51 11 3AZ .