Gap between side window and side panel

WARNING: This page is about a different variant/trim than selected.

Ideal adjustment:

Gaps (A and B) between side window (1) and side panel (2):

Measurement (A) = 10 mm

Measurement (B) = 16 mm

IMPORTANT: Side window glass must run into seal when soft top is closed.

Fig 1: Identifying Gap Between Side Window And Side Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Open loading aid in luggage compartment.

Remove plug (1).

Slacken screw (2) underneath (do not release fully).

Adjust side window by moving (A).

Tightening torque 51 37 3AZ

NOTE: If setting is not achieved: ADJUST POWER WINDOW REGULATOR if necessary

Fig 2: Removing Screw

Courtesy of BMW OF NORTH AMERICA, INC.