Presettings after fitting power window regulator

WARNING: This page is about a different variant/trim than selected.

R52 only:

Preset dimension (A) at power window regulator (1) (window glass breakage); only then may the power window regulator (1) be actuated.

Distance (A) = 18.5 mm

Fig 1: Identifying Power Window Regulator

Courtesy of BMW OF NORTH AMERICA, INC.

Close window completely.

Check gap dimension (A and B) between side window glass (1) and flange on side panel (2) and adjust if necessary.

Distance (A) = 16 mm

Dimension (B) = 10 mm

Fig 2: Identifying Gap Between Side Window And Side Panel

Courtesy of BMW OF NORTH AMERICA, INC.

To do so, slacken screws (1) on power window regulator (2).

Tightening torque 51 37 3AZ

Fig 3: Identifying Screws On Power Window Regulator

Courtesy of BMW OF NORTH AMERICA, INC.

Open soft top and soft top compartment lid.

Fit window cavity cover (1).

Preset dimension (C) between window cavity cover (1) and flange on side panel (2).

Dimension (C) = 24 mm

Installation:

Check function.

Fig 4: Identifying Dimension Between Window Cavity Cover And Flange On Side Panel

Courtesy of BMW OF NORTH AMERICA, INC.