51 14 110 Removing and installing/replacing rear model designation
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
The INSTRUCTIONS FOR NUMBER/LETTER COMBINATION CEMENTING serve as the basis for these repair instructions and must be followed without fail.
Fitting dimensions (R50/R52/R53/R56):
Mark position of model designation with adhesive tape using dimensions (A and B).
Position model designation on marking and stick on.
R50/R52/R53:
MODEL DESIGNATION POSITIONING - R50/R52/R53
| A | B | |
|---|---|---|
| One | 194 mm | 63 mm |
| One D | 194 mm | 68.5 mm |
| Cooper/Cooper S | 194 mm | 48 mm |
R56:
MODEL DESIGNATION POSITIONING - R56
| A | B | |
|---|---|---|
| One | 238 mm | 46 mm |
| Cooper | 238 mm | 52 mm |
| Cooper S | 238 mm | 44 mm |
| Cooper D | 238 mm | 52 mm |
R57:
MODEL DESIGNATION POSITIONING - R57
| A | B | |
|---|---|---|
| Cooper | 235 mm | 27 mm |
| Cooper S | 235 mm | 39 mm |