23 00 040 Installing replacement transmission (GS6-53BG)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
After completion of work, check transmission OIL LEVEL
.
Use only the APPROVED TRANSMISSION OIL .
Use only the APPROVED TRANSMISSION OIL .
Failure to comply with this instruction will result in serious damage to the transmission.
Recycling:
Catch and dispose of escaping transmission fluid.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks:
- Drain gear oil at oil drain plug.
Tightening torque: 43 ± 4 Nm
- Remove TRANSMISSION (without wheel alignment!).
- If necessary, modify zero-gear sensor
- After installing the zero-gear sensor, it is necessary to teach in the position of the zero-gear sensor again
- The adjustment is performed using the "Service Function" of the BMW diagnosis system (learn/write the zero-gear sensor)
Reassemble the vehicle.
Check OIL LEVEL .
The vehicle must be parked on a level surface to check the transmission oil level.