24 21 515 Replacing radial shaft seal for drive shaft (AISIN)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

NOTE: Transmission removed!
Remove torque converter .

Pull off radial shaft seal with special tool 00 5 010 .

IMPORTANT: Do not damage bearing on oil pump.

Fig 1: Identifying Special Tool (00 5 010) With Radial Shaft Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clean sealing surface.

Lubricate sealing lip of shaft seal with clean transmission oil.

Push radial shaft seal (1) onto special tool 24 4 250 and drive firmly home.

IMPORTANT: Do not damage shaft seal (1).

Fig 2: Identifying Special Tool (24 4 250) And Radial Shaft Seal

Courtesy of BMW OF NORTH AMERICA, INC.