24 21 220 Removing radial shaft seal of left axle shaft (AISIN)
WARNING: This page is about a different variant/trim than selected.
Special tools required:
- 23 0 490 . See MANUAL TRANSMISSION - SPECIAL TOOLS - CLUBMAN .
- 24 4 300 . See AUTOMATIC TRANSMISSION - SPECIAL TOOLS - CLUBMAN .
Necessary preliminary tasks:
- Drain off TRANSMISSION OIL .
- Remove left axle shaft . See 31 60 003 REMOVING AND INSTALLING OR REPLACING LEFT OUTPUT SHAFT .
Drive a hole into radial shaft seal using a center punch.
IMPORTANT:
Do not use a drill as drillings may result in transmission malfunction.
Screw special tool 23 0 490 into radial shaft seal (1).
Drive out radial shaft seal (1) with impact weight (2).
Installation:
Coat sealing lips of new radial seal with clean transmission oil.
Drive shaft seal firmly home with special tool 24 4 300 .