24 00 051 Installing an exchange transmission (AISIN)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Transmissions are filled with fluid. Oil level does not have to be compensated!
Only in the event of discernible external damage to exchange transmission or discernible oil leakage from exchange transmission check OIL LEVEL .
Only in the event of discernible external damage to exchange transmission or discernible oil leakage from exchange transmission check OIL LEVEL .
After completing repair work:
- Use only the approved OPERATING FLUID in this automatic transmission.
- Reset adaptation values.
- Perform clutch and gear ratio adaptation.
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Recycling
Catch and dispose of escaping transmission oil.
Observe country-specific waste disposal regulations
Necessary preliminary work
- Remove AUTOMATIC TRANSMISSION .
Convert following components from previous transmission to new transmission.
- Converter, transportation retainer (1).
- Holder, gear selector cable (R56 only)
Tightening torque: 24 11 5AZ
- Holder with retaining clips for wiring harness
- Modify ventilation pipe
- Transportation plate
- Transmission carrier with transmission bearing block (not R56)
Tightening torque 24 11 9AZ .