24 21 515 Replacing radial shaft seal for drive shaft (AISIN)

WARNING: This page is about a different variant/trim than selected.

NOTE: TRANSMISSION removed!

Pull off radial shaft seal with special tool 00 5 010.

IMPORTANT: Important - Do not damage bearing on oil pump.

Fig 1: Pulling Off Radial Shaft Seal Using Special Tool (00 5 010)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clean sealing surface.

Lubricate sealing lip of shaft seal with clean transmission oil.

Push radial shaft seal (1) onto special tool 24 4 250 and drive firmly home.

IMPORTANT: Do not damage shaft seal (1).

Fig 2: Pushing Radial Shaft Seal Onto Special Tool (24 4 250)

Courtesy of BMW OF NORTH AMERICA, INC.