2. General notes for embossed vehicle identification numbers

WARNING: This page is about a different variant/trim than selected.

This procedure is used on all newly launching model series from model year 09/2008 (exception X1).

For the repair new parts with an embossed vehicle identification number can as a rule be ordered from the BMW Parts Department. If this is not possible, observe country-specific regulations.

The IGEF number (bodyshell number) is omitted when the wheel arch is replaced.

If a VIN is embossed into the replacement surface in addition to the original VIN (e.g. if the original VIN has been tampered with), the following applies: The vehicle-specific repair instructions describe the procedure.

The protective film used as standard is omitted after the VIN has been embossed. Ensure that layer thicknesses are small.

Observe national/country-specific regulations.