LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 238 (Body - Repair - Convertible (R57)) >> Body >> 41 00... Safety at work >> 1.1 Working with aluminum dust >> 1.3 Arc welding and brazing

1.3 Arc welding and brazing

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: The extremely bright arc during welding may cause serious injury to the eyes if appropriate protective measures are not taken.
  • Use a special welding screen for the relevant welding method (MAG or MIG).
  • Partition off the workbays with beam protection screens.
  • Use a welding-emissions extractor facility.
  • The welder must wear protective clothing and gloves which are suitable for welding (i.e. flame-proof).
  • A fire extinguisher must be located within reach of the welding area.
  • Do not carry out any welding work in the proximity of a fuel tank e.g. when it is installed.
  • Note national regulations.
scientia non olet · About LEMON Manuals