LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 238 (Body - Repair - Convertible (R57)) >> Body >> 41 00... Opening riveted joints >> 2. Opening punch rivets >> 2.2 Opening punch rivets by drilling out

2.2 Opening punch rivets by drilling out

WARNING: This page is about a different variant/trim than selected.

Drill out rivets with a 6 mm dia. carbide drill bit.

Punch rivets can be drilled out on both sides. When drilling from the protruding rear side, spot-drill the rivet shank only and remove the rest with a rivet punch.

Use a drift punch to remove punch rivet remnants in the aluminum (risk of corrosion).

Clean vehicle to remove chips (risk of corrosion).

scientia non olet · About LEMON Manuals