5.0 Hardening times

• Do not move the vehicle before the adhesive has hardened. 

  Check the degree of hardness of the adhesive with a fingernail.

  If the adhesive cannot be pressed in any further with a fingernail, the vehicle may be moved (without engine force) for further processing applications (e.g. painting).

• Vehicle strength for driving applications  is achieved after:

  48 hours at min. 15 °C object temperature (corresponding to approx. 18 °C room temperature).

  or 1 hour in the spray booth (spray booth temperature 80 °C/object temperature 60 °C).

• When using radiant heaters, make sure that the object temperature does not exceed 85 °C. Excessively high temperatures will destroy the adhesive.
• Remove contamination caused by adhesive residue immediately.

Hardened adhesive can only be removed mechanically.