LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 236 (Front Axle - Repair - Convertible (R57)) >> Output Shaft >> 31 60 535 Replacing both gaiters on left or right output shaft (COOPER S, Diesel and all automatic transmissions) >> Replacing transmission snap ring

Replacing transmission snap ring

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Service kit contains two snap rings for different transmission variants. The rings for the automatic transmission is marked with an "A" sticker. Check that snap ring is correct before installing.
Fig 1: Identifying Circlip
G04796819Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT: The snap rings shown in the cross-section (mm) must not exceed the max. outside diameters specified below after installation

M -> Manual transmission

A -> Automatic transmission

Fig 2: Identifying Snap Ring Max. Outside Diameter Dimension On Manual And Automatic Transmission
G05516190Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals