Removing outer joint gaiter

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: The wheel-side constant-velocity joint is pressed on and secured with a snap ring. Do not press off or disassemble.
Failure to comply with this instruction will result in the constant-velocity joint being damaged.

Fig 1: Identifying Axial Position Mark Of Gaiter To Wheel-Side Joint And Clamping Band

Courtesy of BMW OF NORTH AMERICA, INC.

Mark axial position (1) of gaiter (2) to wheel-side joint (4).

Release clamping bands (3).

Detach gaiter (2) of wheel-side joint.

Wipe accessible areas of hinge (4) with a clean and fluff-free cloth.