11 51 000 Removing and installing/replacing water pump (N12)

WARNING: This page is about a different variant/trim than selected.

WARNING: Danger of scalding!
Only perform these tasks on an engine that has cooled down.

Recycling

Catch and dispose of drained coolant.

Observe country-specific waste-disposal regulations.

Necessary preliminary tasks:

Release screws (1).

Installation:

Replace seal.

Clean sealing surfaces.

Fig 1: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

VENTING INSTRUCTIONS must be observed without fail .