Removal - lower tire bead

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Apply sufficient antiseize compound between rim and tire.

Position fitting head (1) in direction of rotation before sensor (2).

Position tire iron (3) on fitting head (1).

Tyre bead must be positioned entirely in well opposite fitting head (1).

Fig 1: Positioning Fitting Head

Courtesy of BMW OF NORTH AMERICA, INC.

Lever bead with tire iron (1) over rim flange.

IMPORTANT: Avoid damaging the rim by using a suitable tire iron with protective coating.

Allow fitting machine to rotate slowly.

Fig 2: Levering Tyre Bead Using Tyre Iron

Courtesy of BMW OF NORTH AMERICA, INC.