36 11 533 Removing and installing/replacing a tire pressure control electronic wheel module (Generation I): Notes
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Before removing and installing, check which generation of tire pressure control electronic wheel modules are fitted (See BMW parts catalogue)
If the electronic wheel module has been removed, the complete valve must be replaced.
These instructions describe how to install the (old) 2-time operating valves. These can be used if still in stock.
See 1-TIME OPERATING VALVES .
If the electronic wheel module has been removed, the complete valve must be replaced.
These instructions describe how to install the (old) 2-time operating valves. These can be used if still in stock.
See 1-TIME OPERATING VALVES .
NOTE:
If a tire sealant has been used, replace the electronic wheel module.
When a tire has been removed, do not clean the rim with installed electronic wheel module with high-pressure cleaner.
Before the installation of new wheel electronics with valve, thoroughly clean the valve bore of the wheel rim.
Do not treat electronic wheel module with solvents, cleaning agents etc. If dirty, wipe with a clean cloth only.
Do not clean electronic wheel module with compressed air.
Necessary preliminary tasks:
- Remove TIRE