36 11 533 Removing and installing/replacing RDC wheel electronics (2nd generation/3rd generation): Notes
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Before removing or refitting, check which generation of wheel modules is fitted (see BMW Spare Parts Catalogue).
If the electronic wheel module has been removed, the complete valve must be replaced.
If the electronic wheel module has been removed, the complete valve must be replaced.
NOTE:
There are two different electronic wheel modules. The SP303 electronic wheel module must be used with RDC-01 and RDC-02 from model year 03/06.
The Gen3 electronic wheel module must be used with RDC-LC from model year 09/09.
The Gen3 electronic wheel module must be used with RDC-LC from model year 09/09.
If a tire sealant has been used, replace the electronic wheel module.
When a tire has been removed, do not clean the rim with installed electronic wheel module with high-pressure cleaner.
Before the installation of new wheel electronics with valve, thoroughly clean the valve bore of the wheel rim.
Do not treat electronic wheel module with solvents, cleaning agents etc. If dirty, wipe with a clean cloth only.
Do not clean electronic wheel module with compressed air.
Necessary preliminary tasks:
- Remove TIRE