54 61 021 Removing and installing/replacing trims for rollover protection

WARNING: This page is about a different variant/trim than selected.

NOTE: Tape off work area in order to avoid damage.

Fig 1: Unclipping Upper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip upper trim (1) with plastic wedge.

Installation:

Retaining lugs must not be damaged nor must trim (1) be scratched.

If necessary, replace trim (1).

Trim (1) is coded against incorrect installation.

Unclip lower trim (1) with plastic wedge.

Installation:

Retaining lugs must not be damaged nor must trim (1) be scratched.

If necessary, replace trim (1).

Trim (1) is coded against incorrect installation.

Fig 2: Unclipping Lower Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Fig 3: Identifying Trim Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully unclip upper trim from lower trim.

Installation:

Retaining lugs on lower or upper trim must not be damaged.

If necessary, replace faulty trims.

Fig 4: Unclipping Upper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out clip (1).

Installation:

Replace faulty clip (1).

Feed out lower trim (2).

Fig 5: Removing Lower Trim

Courtesy of BMW OF NORTH AMERICA, INC.