Retaining plate, soft top

WARNING: This page is about a different variant/trim than selected.

Before removing Convertible top with retaining plate, mark position of main bearing in relation to body.

When installing Convertible top, align main bearing with retaining plate to markings.

Fig 1: Identifying Retaining Plate, Soft Top

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove connecting bracket (2).

Tightening torque 51 37 04AZ .

Fig 2: Removing Connecting Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Feed out Convertible top retaining plate upwards between power window unit and side member.

Installation:

If necessary, adjust distance for soft top LONGITUDINAL ALIGNMENT .

Tighten screw (1).

Fig 3: Removing Convertible Top Retaining Plate

Courtesy of BMW OF NORTH AMERICA, INC.