34 00 050 Bleeding brake system with DSC: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
Read and comply with GENERAL INFORMATION .
When replacing or repairing, observe the filling and bleeding instructions for the following parts:
- Tandem brake master cylinder
- Hydraulic unit
- Components and connecting lines which are fitted between these assemblies.
Connect bleeder unit with max. 2 bar filling pressure.
A second person is needed to help carry out this work.
Always use MINI-approved brake fluids, refer to OPERATING FLUIDS
Connect Diagnosis and Information System.
Open cover (1).
Connect bleeder unit to expansion tank (2) and switch on.
Connect DIS.
Select path: Service functions - Chassis/Suspension - Traction control systems - Bleeding procedure.
IMPORTANT:
Check relevant equipment manufacturer's operating instructions for each device.
Charging pressure should not exceed 2 bar.
Charging pressure should not exceed 2 bar.