If the measured value is greater than the nominal value + 0.2 bar
WARNING: This page is about a different variant/trim than selected.
- Turn off engine stop and then observe measured value.
- If measured value drops to nominal value, then line cross-sections in fuel return are constricted or clogged.
- Check the fuel lines for kinks.
If no kinks are visible:
- Replace return lines
If measured value remains too high, then pressure regulator is in all probability faulty.
IMPORTANT:
With less likelihood, the return line may be completely blocked. When the pressure regulator is removed, fuel could escape under pressure!
- Have a cleaning cloth ready and catch and dispose of escaping fuel.
- Replace the return line but not the pressure regulator.