33 00... Rear axle: wheel/chassis alignment check must be carried out after the following work

A wheel/chassis alignment check must be carried out after the following work:

• Release of following screw/bolt connections: 
  • Trailing arm bracket to body
  • Upper control arm to rear axle carrier
  • Lower control arm to rear axle carrier/trailing arm
• Replacement of following parts: 
  1. Rear axle carrier
  2. Upper control arm
  3. Lower control arm
  4. Trailing arm/trailing arm bracket/rubber mount
Fig 1: Identifying Rear Axle Components
Courtesy of BMW OF NORTH AMERICA, INC.

See ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION - or - ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD .