72 11 Seat belts
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - SEAT BELTS
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Height adjuster, seat belt, front - to "B-pillar" | R50/R53 | M8 | 22 Nm | |
| 2AZ Front seat belt automatic reel - to "B-pillar" | R50/R53 | Replace screws. | 29 Nm | |
| R52/R55/R56 | Replace screws. | 36 Nm | ||
| R57 | Replace screws. | 31 Nm | ||
| R60 | Replace screws. | 40 Nm± 4 | ||
| 3AZ Seat belt guide loop - to height adjuster | R50/R53 | M10 | 36 Nm | |
| -to body | R55/R56 | M10 | 36 Nm | |
| R60 | M10 | 40 Nm ± 4 | ||
| 4AZ Front seat belt, end fitting; sliding rail | R50/R52/R53 | Screws are coated and must be replaced. | 36 Nm | |
| R55/R56 | Screws are coated and must be replaced. | 36 Nm | ||
| R57/R60 | Screws are coated and must be replaced. | 40 Nm± 4 | ||
| 5AZ Rear seat belt automatic reel | ||||
|
R50/R52/R53/R55/R56 | replace screws | 36 Nm | |
|
R55 | replace screws | 36 Nm | |
|
R57 | replace screws | 40 Nm | |
6AZ Belt deflection fitting for rear passenger compartment seat belt
|
R50/R52/R53/R55/R56 | 36 Nm | ||
| 7AZ Rear seat belt end fitting | R50/R52/R53/R55/R56 | Replace coated screw. | 36 Nm | |
| R57/R60 | Replace coated screw. | 40 Nm± 4 | ||
| 8AZ Buckle (lower strap), rear passenger compartment seat belt | R50/R52/R53/R55/R56 | M10 | Replace coated screw. | 36 Nm |
| R60 | Replace screws. | 40 Nm± 4 | ||
| R57 | Use New Screws | 40 Nm | ||
| 9AZ Lower strap (belt tensioner), seat belt, front | R50/R53 | M10 | Replace screws. | 45 Nm |
| R55/R56/R57 | M10 | Replace screws. | 36 Nm | |
| R60 | Replace screws. | 40 Nm± 4 | ||
| 10AZ Seat belt guide loop to body (B-pillar) | R52/R57 | 25 Nm | ||
| 11AZ Belt guide loop | R52 | 11 Nm | ||
| 12AZ automatic reel connection plate | R57 | 40 Nm | ||
13AZ Belt deflection fitting for rear passenger compartment seat belt
|
R57 | 32 Nm | ||
14AZ Belt deflection fitting for rear passenger compartment seat belt
|
R57 | 18 Nm | ||
| 15AZ Belt deflector | R60 | M10 | oval-head screw for thin sheet | 4 Nm±1.5 |