54 34 Motor-driven Convertible Top (Electrical Components)
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - MOTOR-DRIVEN CONVERTIBLE TOP (ELECTRICAL COMPONENTS)
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Main bearing, convertible top, to retaining plate | R52/R57 | 18.5 Nm | ||
| 2AZ Retaining plate, convertible top, to side member | R52/R57 | 10 Nm | ||
| 3AZ Base plate, convertible top | R52/R57 | 7.6 Nm | ||
| 4AZ Bearing, clamping bar, convertible top to body | R52/R57 | 9.5 Nm | ||
| 5AZ Pin, clamping bar to body | R52/R57 | 7.6 Nm | ||
| 6AZ Mounting, main bearing | R52 | 2 +0.2 Nm | ||
| 7AZ Roof crossbar to convertible top frame | R52 | 8 Nm | ||
| 8AZ Front bow to roof crossbar | R52 | 7.2 Nm | ||
| 9AZ Drive to roof crossbar | R52 | 2.9 ±0.5 Nm | ||
| 10AZ Trim strip, convertible top, to tension bar | R52 | 2.4 Nm | ||
| 11AZ Pin, loose fabric | R57 | 10 Nm | ||
| 12AZ Clamping bar to bearing | R57 | 9.5 Nm | ||
| 13AZ Soft top storage lock | R59 | 5 Nm | ||
| 14AZ Soft-top bow to body | R59 | 3.5 Nm | ||
| 15AZ Stowage lock to soft top frame | R57 | 8 Nm | ||
| 16AZ Cover, C-pillar to main pillar | R57 | 6 Nm | ||
| 17AZ Main pillar to soft top frame | R57 | 8 Nm | ||
| 18AZ Guide pin to main pillar | R57 | 8 Nm |