51 11 Front Bumper
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - FRONT BUMPER
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Spoiler, bumper, lower, to front panel | R50, R52, R53 | M6 | 6 Nm | |
| 2AZ Bumper to front panel | R50, R52, R53 | M6 | 6 Nm | |
| 3AZ Support to body | R50, R52, R53, R55, R56 | M8 | Nut | 22 Nm |
| R60 | M10 | Nut | 45 Nm | |
| 4AZ Support to holder, bumper, front | R52/R53/R50/R60 | M8 x 20 | Screw | 22 Nm |
| R55, R56 | M8 | 18.5 Nm | ||
| 5AZ Adjusting fixture to front panel | R50, R52, R53 | M6 x 20 | 6 Nm | |
| 6AZ Adjusting device to bumper | R50, R52, R53 | M6 x 20 | 6 Nm | |
| 7AZ Lock bridge to body | R55/R56/R60 | 22 Nm | ||
| 8AZ Support to front panel | R60 | 4 Nm | ||
| 9AZ Strut to front panel | R60 | M6 | 8 Nm |