33 32 Control Arms and Struts
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - CONTROL ARMS AND STRUTS
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Upper control arm to trailing arm | R55/R56/R57 | M12 | Replace nut TIGHTEN IN NORMAL POSITION | 100 Nm |
| 2AZ Lower control arm to trailing arm | R55/R56/R57 | M12 | TIGHTEN IN NORMAL POSITION | 100 Nm |
| 3AZ Control arm to rear axle carrier | R55/R56/R57 | M12 | Replace nut TIGHTEN IN NORMAL POSITION | 100 Nm |
| 4AZ Holder, trailing arm to trailing arm | R55/R56/R57 | M14 | TIGHTEN IN NORMAL POSITION | 165 Nm |
| 5AZ Holder, trailing arm to body | R55/R56/R57 | M12 | 100 Nm |