31 12 Handlebars and struts
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - HANDLEBARS AND STRUTS
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Wheel control joint to wishbone | R55/R56/R57 | M14 | Replace nuts. | 175 Nm |
| R60 | M14 | Replace nuts. Jointing torque Angle of rotation |
50 Nm 90° |
|
| 2AZ Wheel control joint to swivel bearing | R55/R56/R57 | M12 | Replace nut. Jointing torque Angle of rotation |
70 Nm 90° |
| R60 | M10 | Replace screw. | 60 Nm | |
| 3AZ Ball joint, inner, to front axle support | R55/R56/R57 | M14 | Replace nut. Jointing torque Angle of rotation |
70 Nm 90° |
| R60 | M14 | Replace nuts. Jointing torque Angle of rotation |
80 Nm 80° |
|
| 4AZ Holder, wishbone rubber mount, to front axle support | R55/R56/R57/R60 | M14 | 165 Nm | |
| 5AZ Holder, wishbone rubber mount, to body | R55/R56/R57/R60 | M10 | Replace screws. Jointing torque Angle of rotation |
59 Nm 90° |