21 00 006 Bleeding clutch hydraulic system

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

IMPORTANT: Check relevant Operating Instructions for each device.
Charging pressure should not exceed 2 bar.

Remove dust cap from bleed valve.

Connect bleeder hose to bleed valve (1).

Fig 1: Connecting Bleeder Hose To Bleed Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Open bleed valve (1) and flush until clear brake fluid emerges without air bubbles.

Close bleed valve.

Switch off bleeder unit or remove from expansion tank.

Correct brake fluid level in expansion tank.

Fig 2: Opening Bleed Valve

Courtesy of BMW OF NORTH AMERICA, INC.