18 31 Exhaust system, complete
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - EXHAUST SYSTEM, COMPLETE
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Catalytic converter to turbocharger | N14/N18 | M8 | Initial torque | 7 Nm |
| Final torque | 40 ± 6 Nm | |||
| 2AZ Stud bolts to turbocharger | N14/N18 | M8 | 10 Nm | |
| 3AZ Catalytic converter to holder | N14/N18 | M8 | Replace nuts. | 20 ± 5 Nm |
| 4AZ Holder, catalytic converter, to crankcase | N14/N18 | M8 | 20 ± 5 Nm | |
| 5AZ V-band clamp, exhaust system, to catalytic converter | N12/N14/N16/N18 | 25 ± 3 Nm | ||
| 6AZ Clamp | N12/N14/N16/N18 | 45 Nm | ||
| 7AZ Exhaust system to transmission | R60/N16/N18 | M8 | 19 Nm | |
| 8AZ Exhaust system to stiffening plate | R60/N16/N18 | M8 | 19 Nm | |
| 9AZ Struts, stiffening plate | R60/N16/N18 | M10 | 65 Nm | |
| 10AZ Reinforcement plate to body | R60/N16/N18 | M8 | 19 Nm | |
| 11AZ Exhaust system to body | R60/N16/N18 | M8 | 19 Nm |