11 36 Variable Camshaft Control
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - VARIABLE CAMSHAFT CONTROL
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ VANOS to inlet and exhaust camshafts | N12 | M10x52 | Replace screw Jointing torque Torque angle |
20 Nm 180 ° |
| 2AZ Non-return valve VANOS to cylinder head | N12 | M14 x 1.5 | Replace sealing ring | 13 Nm |
| 3AZ Solenoid valve holder to crankcase | N12 | M6x16 | 9 Nm |