11 11 Engine block
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - ENGINE BLOCK
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Main bearing bolts, observe tightening specifications. | N12 | M9x115 | Replace bolts Jointing torque Angle of rotation |
30 Nm 150 ° |
| 2AZ Bedplate, observe tightening specifications. | N12 | M6 | Replace bolts Jointing torque |
9 Nm |
| 3AZ Screw plug, gear case upper section | N12 | M22x1.5 | 50 Nm | |
| 4AZ Screw plug, gear case lower section | N12 | M16x1.5 | Replace gasket | 30 Nm |
| 5AZ Oil baffle to crankcase lower section | N12 | M6x100 | 10 Nm | |
| 6AZ Screw plug, gear case lower section | N12 | M16x1.5 | Replace gasket | 30 Nm |
| 7AZ Screw plug, gear case lower section | N12 | M16x1.5 | Replace gasket | 30 Nm |
| 8AZ Screw plug | N12 | M16x1.5 | Replace gasket | 32 Nm |
| 9AZ Bearing journal | N12 | M8x1.25 | Replace O-ring | 23.5 Nm |