18 00 020 Removing and installing complete exhaust system (N12)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

31 2 220 . See FRONT AXLE - SPECIAL TOOLS -- CLUBMAN .

WARNING: Danger of burning and other injuries!
These tasks should only be carried out on an exhaust system that has cooled down.
Removal of the exhaust system must be carried out with the assistance of a second person.
Support exhaust system (1) with a suitable jack (2). Secure exhaust system against falling off.

Fig 1: Identifying Exhaust System With Suitable Jack

G06907576

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten clip.

Tightening torque 22-28 N.m.

Fig 2: Locating Clip

G04796561

Courtesy of BMW OF NORTH AMERICA, INC.

Spray rubber mount (1) with antiseize agent and detach from exhaust pipe (2).

Fig 3: Identifying Rubber Mount And Exhaust Pipe

G04796564

Courtesy of BMW OF NORTH AMERICA, INC.

Support exhaust system with a suitable lifter.

Release screws and remove cross-brace (1).

Fig 4: Locating Screws

G05515892

Courtesy of BMW OF NORTH AMERICA, INC.

Spray rubber mount (1) with antiseize agent and detach from rear muffler (2).

NOTE: Illustration shows and text refers to the right rubber mount.
The procedure is identical for the left side.

Lower and remove exhaust system with assistance of a second person.

Fig 5: Identifying Rubber Mount And Rear Muffler

G04796559

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check rubber mount for damage, replace if necessary.