12 14 521 Replacing Pulse Sensor On Crankshaft (N12, N14)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

NOTE: For purposes of clarity, the following work step is shown on the engine after it has been removed.

Remove cover (1).

Fig 1: Identifying Crankshaft Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug (1) and remove.

Release screw and remove pulse sensor.

Tightening torque 13 62 3AZ .

Fig 2: Identifying Crankshaft Plug

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault messages.
Delete fault memory.