Adjusting camber
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Observe following sequence:
- Raise car (wheels free)
- Slacken screw (1).
- Adjust camber by turning eccentric disk (2) in direction of max. positive (wheel at bottom is at max. in relation to center of car)
- Tighten screw (1) slightly
- Lower vehicle and compress.
- Slacken screw (1) and adjust camber by turning eccentric disk (2) to setpoint value
- Tighten down screw (1)
Installation:
Tightening torque 33 32 2AZ .