Pistons with rings and pins N12 (2 of 2)
WARNING: This page is about a different variant/trim than selected.
NOTE:
For diameter of cylinder bore, refer to ENGINE BLOCK, CYLINDER CRANKCASE .
PISTONS WITH RINGS AND PINS SPECIFICATION
| 1st groove | ||
| End clearance | mm | 0.25... 0.35 |
| Contact clearance (wear limit) | mm | 0.91 |
| Axial play | mm | 0.030... 0.070 |
| 2nd groove | ||
| End clearance | mm | 0.35... 0.50 |
| Contact clearance (wear limit) | mm | 1.06 |
| Axial play | mm | 0.030... 0.070 |
| 3rd groove | ||
| End clearance | mm | 0.10... 0.35 |
| Contact clearance (wear limit) | mm | 0.82 |
| Axial play | mm | 0.030... 0.070 |