Pistons with rings and pins N12 (1 of 2)
WARNING: This page is about a different variant/trim than selected.
NOTE:
For diameter of cylinder bore, refer to ENGINE BLOCK, CYLINDER CRANKCASE .
PISTONS WITH RINGS AND PINS SPECIFICATION
| Piston and pin are paired to each other - replace together only. | ||
| Measuring point "A" (position) | mm | 10 |
| Piston diameter at measuring point "A" | ||
| Original (new dimension) | mm | 76.941... 76.995 |
| Piston running clearance | mm | 0.041... 0.064 |
| Permissible total wear tolerance between piston and cylinder (engine operated) | mm | 0.10 |