11 12 Cylinder Head with Cover N12
WARNING: This page is about a different variant/trim than selected.
CYLINDER HEAD WITH COVER SPECIFICATION
| The cylinder head sealing face must not be remachined | ||
| Inside diameter of installed valve guide | mm | 5.000... 5.012 |
| Running clearance between valve and valve guide | ||
| Intake | mm | 0.025... 0.047 |
| Exhaust | mm | 0.033... 0.060 |
| Maximum running clearance between valve and valve guide | ||
| Wear limit: Intake | mm | 0.08 |
| Wear limit: Exhaust | mm | 0.10 |