13 54 030 Removing and installing/sealing throttle valve assembly (N12)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Unfasten screws.

Tightening torque 13 54 1AZ.

Carefully feed out throttle valve assembly (1) towards top until plug for cable connection is accessible.

Unlock connector and remove.

Remove throttle valve assembly (1).

Fig 1: Identifying Throttle Valve Assembly

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace sealing ring (1).

Fig 2: Identifying Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault messages.
Now clear the fault memory.