13 62 010 Removing and installing/replacing differential pressure sensor (N12)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection)! See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Unlock plug (1) and remove.

Release screw.

Pull differential pressure sensor (2) out of intake air manifold.

Installation:

Check sealing ring, replace if necessary.
Tightening torque 13 62 1AZ.

Fig 1: Identifying Plug And Differential Pressure Sensor
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check stored fault messages.

Now clear the fault memory.