11 36 655 Removing and installing/replacing both solenoid valves (N14)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Always check that the solenoid valves are clean during removal and installation.

Possible malfunction if valves are contaminated:

Necessary preliminary tasks:

Disconnect plug connection for solenoid valve (3) - inlet.

Release screw (1).

Remove solenoid valve (2) for inlet side.

Fig 1: Identifying Solenoid Valve With Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace sealing ring on solenoid valve.

Fig 2: Identifying Sealing Ring On Solenoid Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Check function of DME.