11 25 671 Replacing piston rings on all pistons (N14)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Measuring axial clearance of piston rings in piston ring groove.

NOTE: It is not possible to measure the axial clearance of the oil scraper rings.

Fig 1: Measuring Axial Clearance Of Piston Rings

Courtesy of BMW OF NORTH AMERICA, INC.

Remove compression ring and stepped ring upwards with piston ring pliers.

Oil scraper ring comprises two steel band rings and a support spring.

NOTE: Oil scraper ring cannot be removed with piston ring pliers.

Put aside piston rings in correct sequence and installation position.

It might not be possible to find the identification on used piston rings.

Fig 2: Removing Compression Ring And Stepped Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

New pistons may only be installed together with new piston rings.

Determine GAP with a feeler gauge.

Fig 3: Measuring Gap Using Feeler Gauge

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Piston rings with "TOP" identification must point to piston crown.

Fig 4: Identifying Piston Rings With TOP Identification

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Piston rings with "TOP" identification must point to piston crown.

Fig 5: Identifying Compression Ring, Taper Face Ring And Oil Scraper Ring

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Oil control ring comprises two steel band rings (1) and a support spring (2).

Installation:

Insert support spring (2) into piston ring groove and then fit steel band rings (1) so that contact points are offset by approx. 120°.

Fig 6: Identifying Steel Band Rings And Support Spring

Courtesy of BMW OF NORTH AMERICA, INC.

Offset the contact points (1) of the piston rings by approx. 120° to each other but do not position above the piston pin boss.

Coat special tool 11 9 670 with sufficient engine oil Risk of damage! to piston rings!

NOTE: See graphic.

Fig 7: Identifying Piston Rings Contact Points

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.