12 41 020 Removing and installing/replacing starter motor (N12, N14, N16, N18)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary work:

Switch off ignition.
Clamp off battery. See 61 00... Instructions for disconnecting and connecting battery .
Remove INTAKE SILENCER HOUSING .
Remove right wheel.
N12 and N16 only:

Remove tank vent valve.

NOTE: For a better overview, the following operation is shown on the engine after it has been removed.

N14 and N16 only

Loosen screws and set vacuum tank (1) aside.

Fig 1: Identifying Vacuum Tank With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw.

Tightening torque 12 41 1AZ .

Fig 2: Identifying Vacuum Tank Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and remove.

Release nut (2) and remove the positive battery cable.

Tightening torque 12 41 2AZ .

Release screws.

Tightening torque 12 41 1AZ .

Remove holder (3) and starter motor.

Fig 3: Identifying Connector, Nut And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Install starter motor and fit screws.

Press starter motor (1) in direction of arrow and tighten down.

Fig 4: Pressing Starter Motor

Courtesy of BMW OF NORTH AMERICA, INC.