13 53... Pressure line leak test
WARNING: This page is about a different variant/trim than selected.
WARNING:
- Risk of burning!
- Rotating components (risk of injury!)
Necessary preliminary work
- Remove INTAKE SILENCER HOUSING .
- Bring engine up to operating temperature.
IMPORTANT:
Air bubbles form continuously in the event of a leak!
Static air bubbles indicate that there is no leak. They may be caused by the leak detector spray or when the leak detector agent liquefies.
Picture shows N14
Apply leak detector spray in area of screw connection (1) of pressure line (2).
Repeat procedure several times and check for bubbles with telescopic mirror in the entire screw connection area (1).
NOTE:
In case of tightness:
- Assemble engine
- Read out fault memory, clear if necessary.
In event of leakage:
- Replace both components at leak
- Repeat leak test after replacing components